The XY Controller page is actually only one controller, but link it twice to two different parameters, disable 'Remove conflicts' and use the corresponding mapping formula presets, so X and Y position are mapped to each link. Use the smoothing knob in the controller link window to smooth the parameter changes as you press between buttons. To link a controller to a parameter in FL Studio, right click the knob or fader, select 'Link to controller', enable 'Auto detect', then press a button on the layout on the Launchpad. Select two channels at the same time in the step sequencer window of FL Studio to use the C Major + Slicex page for two different instruments at the same time.Ĭontroller layouts allow parameters to be controlled by a group of buttons. Use the Prev/Next Channel buttons on the right to change the target channel. Note layouts control the currently selected channel in the step sequencer window. To access more than the first 7 pages you continue to use the navigation buttons. Or if you are currently viewing the top left most Performance zone on the Launchpad, press the left navigation button twice or more. Press OVERVIEW then one of the other round buttons on the right hand side of the Launchpad, to jump to note and controller layout pages.
Press and hold a pad on a track or control page, right click a parameter in FL Studio, enable Auto detect and push down on the pad to link it to the pressure message. Navigate vertically to access other tracks.Įach clip launching track or controller page sends a separate pressure message that can be linked to a parameter. On this page the buttons change and display each tracks settings even during playback in Performance mode. Or if you are currently viewing the top left most Performance zone on the Launchpad, press the left navigation button once. Press OVERVIEW then the top right most round button to jump to the realtime Track settings page. In this mode the 8 round buttons on the right are used to jump to the Track settings page or the note or control layout pages. Press a button to jump to that zone on the Launchpad. In this mode the main 8x8 set of square buttons show the currently used Performance zones in the Playlist. Press the OVERVIEW button to go into Overview mode.
0 kommentar(er)
